Understand and learn how to apply the ANSI/ASQ Z1.9 (formerly MIL STD 414) standard for acceptance sampling by variables.

">

Sampling by Variables (ANSI/ASQ Z1.9)

Start Date : June 20, 2018
End Date : June 20, 2018
Time : 1:00 pm to2:00 pm

Phone : 18883008494
Email : support@trainingdoyens.com

Description

OVERVIEW

ANSI/ASQ Z1.9 (formerly MIL STD 414) uses sample statistics to determine whether a production lot, or incoming lot, should be accepted or rejected. These statistics also allow estimation of the nonconforming fraction at each specification limit. Attendees will learn how to define a sample plan on the basis of (1) the lot size, (2) the inspection level, and (3) the acceptable quality limit (AQL).

ANSI/ASQ Z1.9 can be used for single specification limits, two-sided specification limits, and even two-sided limits with different AQLs. Attendees will learn everything they need to know to address all three of these applications.

Switching rules meanwhile dictate normal, tightened, or reduced inspection according to production performance. Poor quality results in tightened inspection, while a consistent history of good quality and consistent production conditions allows reduced inspection. In addition, if the process is under control and its standard deviation is known, a considerably smaller sample size is required.

WHY SHOULD YOU ATTEND

ANSI/ASQ Z1.9 is a widely recognized and generally accepted standard for acceptance sampling by variables. It uses the average and standard deviation (or range) of a sample of n parts to determine whether the lot from which the sample was drawn should be accepted or rejected. The technology is very straightforward, but users must also be aware of the often-overlooked fact that the standard relies on the assumption that the part measurements follow the normal or bell curve distribution. If this is not the case, the standard will not deliver the intended or expected results.

Attendees will also learn pitfalls that are involved in use of the sampling tables, and also use of the range method. It is important to remember that this approach uses the average range of samples of 5, rather than the range of (for example) all 15 parts in the sample.

Handouts will include a technical appendix that shows the derivation of some of the material in the standard such as operating characteristic (OC) curves, and an Excel spreadsheet that duplicates tables B5 and D5, which return estimates of the nonconforming fraction in the lot when the standard deviation is estimated from the sample statistics (B5) or known from prior experience (D5).

AREAS COVERED

LEARNING OBJECTIVES

This webinar will equip attendees to understand and apply the ANSI/ASQ Z1.9 (formerly MIL STD 414) standard for acceptance sampling by variables (real number data), along with vital considerations such as the need to test the measurements for conformance to the normal (bell curve) distribution.

WHO WILL BENEFIT

Quality engineers, technicians, and inspectors who use ANSI/ASQ Z1.9 (formerly MIL-STD 414)

 

For more detail please click on this below link:

https://goo.gl/1vwM24

 

Email: support@trainingdoyens.com

Toll Free: +1-888-300-8494

Tel: +1-720-996-1616

Fax: +1-888-909-1882

Organized by

Organized by Training Doyens

Training Doyens ,
26468 E Walker Dr, Aurora, Colorado 80016

Understand and learn how to apply the ANSI/ASQ Z1.9 (formerly MIL STD 414) standard for acceptance sampling by variables.

Tel: 8883008494
Mobile: 18883008494
Email: support@trainingdoyens.com
Website: https://goo.gl/1vwM24


Event Categories: Business Practice.

Your Review

You must be logged in to post a comment.